Description
๐๐๐ฌ๐๐ซ๐ข๐ฉ๐ญ๐ข๐จ๐ง ๏ผ
This APC by Schneider Electric Rack Power Distribution Unit, the Easy PDU, may be used as a stand-alone, network-manageable power distribution device. The Easy PDU provides real-time remote monitoring of connected loads. User-defined alarms warn of potential circuit overloads. You can manage an Easy PDU through its Web User Interface (Web UI), or Simple Network Management Protocol (SNMP).
๐
๐๐๐ญ๐ฎ๐ซ๐๐ฌ ๏ผ
โข Device power, apparent power, power factor and energy.
โข Phase voltage, current.
โข Configurable alarm thresholds that provide network to help avoid overloaded circuits.
โข Various levels of access: Super User and General User. (Only one user allows to log in simultaneously at same access level).
โข Event logging.
โข Modbus-TCP (disabled as default configuration)
โข SNMP traps (V1, V2c, and V3).
โข Security protocols for authentication and encryption.
โข Synchronize the time with the SNTP Server.
๐๐ฎ๐ข๐๐ ๐ญ๐จ ๐ข๐ง๐ฌ๐ญ๐๐ฅ๐ฅ ๏ผ
1. Install the Easy PDU using the Installation Instructions that were shipped with your device.
2. Apply power and connect to your network. Follow the directions in the Installation Instructions.
3. Establish network settings (See โEstablish Network Settingsโ on page 3.)
4. Begin using the Easy PDU by way of one of the following:
โ Web User Interface (See โWeb User Interfaceโ on page 5.)
โ Easy PDU Front Panel (See โFront Panel Overviewโ on page 4.)
โ SNMP protocol (See โSNMP Settingsโ on page 8.)
๐๐ญ๐๐ญ๐ข๐ ๐๐ ๐๐จ๐ง๐๐ข๐ ๐ฎ๐ซ๐๐ญ๐ข๐จ๐ง๏ผ
You must define three TCP/IP settings for the Easy PDU before it can operate on the network:
โข The IP address of the Easy PDU
โข The subnet mask of the Easy PDU
โข The IP address of the default gateway (only needed if you are going off segment)
Reviews
There are no reviews yet.